                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3514044
Skywatcher 130PDS Bahtinov Mask by RolandKol is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Bahtinov Mask for Skywatcher 130PDS.
Fits nicely.
I did this one as the one I bought from astro shop, was very dark with gaps only in the central area.
This model, has gaps using a whole 150mm (OTA's diameter) area, therefore allows to use shorter exposures or lower gain/iso during focusing.

Size: 150mm x 3mm
Central obstruction lines 7mm
Small obstruction lines: 2.4mm with 2.4mm gaps

Would be happy to receive any advice/recommendations on how to increase the quality.

# Print Settings

Printer Brand: Anycubic
Printer: All-metal Mega
Supports: Doesn't Matter
Resolution: 0.3
Infill: 33%
Filament_brand: Any
Filament_material: PLA/PETG

Notes: 
I used 0.3mm layer to print it faster.
Good bed level needed